Because of the many possibilities of these ignitions,
please follow the step-by-step configurator below.

In most cases you will have to make some adjustments for these blank sets to fit onto your engine.
This is necessary to properly line up the pick-up (pulser) with the signal disc.
This could mean constructing a baseplate, adjusting the shaft, or adjusting the signal disc.

2. Mounting shaft

Where will the ignition be installed?


Information:

  • Select the same location your currect ignition/contact breaker is located
  • Camshafts are only used on 4 stroke engines
    => 2 stroke ignitions are always mounted on the crankshaft
  • To the right is a picture to indicate the difference between the crankshaft and the camshaft (click to enlarge)
< Previous step
Next step >
Shopping basket 0 Products
Total
€0,00
Continue shopping
Go to checkout